Buffer Cleaner
Oman Chemical is leading one Largest Supplier, Manufacture a
Versatile emulsifier and strong cleaner, which can be used to clean petroleum based product, Lube oil, soften up / remove baked on drying oils and used after animal and vegitable oils, fish oils, tall oils, tug oils, Phthalates paraffin's etc .It is low toxic product with an exceptional solvency power on soil & oily matter. It is free from hydrocarbon solvents, Biodegradable minimizes the extreme hazards to personnel in handling materials.
Suitable for cleaning of Lube oils Gas oil Kerosene Mineral oil Products. Phthalates paraffin's vegetable oils Odour intensive products.
Using-Procedure:-First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of usin RXSOL-20-2028-210 is by direct injection followed by recirculation washing, using tank cleaning machines.
Spraying Method:-Using CTC as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butterworth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages. Inspects tanks(s) and if desired result has been achieved fresh water rinse and dry.
**Make sure to take all safety precautions are followed when handling / spraying CTC**
Injection Method:- Not applicable.
Re- Circulation Method:- Fill tank with fresh water and heat up to warm 50oC . IF a drop line is available on the tank line system, then start to circulate the water and add the required amount of Caustic flakes and CTC to make a 2.5% solution. A stronger solution can be made, but be advised that too much Caustic and too high temperature will result in white powder all over the tank. Under normal circumstances, between 2.5% and 4.5% will be sufficient strength. If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.
**Use a strainer at the pump stack when circulating any solution.** Tank Lining– Stainless / Epoxy / Phenolic / Zinc
Necessary concentration in water only 0,2 to 0,4 %
Versatile emulsifier and strong cleaner, which can be used to clean petroleum based product, Lube oil, soften up / remove baked on drying oils and used after animal and vegitable oils, fish oils, tall oils, tug oils, Phthalates paraffin's etc . Only small dose of this cleaner in water 0.2 to 0.4 % , plays very good emulsification and cleaning role during tank cleaning process. CTC cleaner can be blend easily with any other tank cleaner to enhance cleaing action. CTC cleaner gives buffer action with all claner like Metal Bright, LAC, Sea-cleaner, Alkaline Cleaner etc. CTC VOLC cleaner is fully developed by our R & D team with extra valuable cleaning and emulsification feature. During our product development we observd that this product cleaning power can be increase by addition of Metal Bright or LAC during cleaning operation. We are keeping good quantities of this material at our all INDIAN - Middle East coastal location.
Note:- Acts as an acid-neutralizing agent also.
We are marine chemical supplier since 1996.These Marine Chemicals include different sets of products such as Tank Cleaners, Maintenance Chemicals, Cooling Water Treatment Chemicals, Boiler Water Treatment Chemicals, Fuel Additives, etc.
Oman Chemical is leading one Largest Supplier, Manufacture a
Oman Chemical is leading one Largest Supplier, Manufacture a
