Activated Carbon Powdered
- Part number
- RXSOL-26-3107-555
- Category
- Carbon Coal Charcoal
- Brand
- RXSOL
Overview
Technical specifications
Applications
RXSOL Coal Based Activated Carbon used in Natural gas liquids and field condensate purification: RXSOL Activated Coal Cartbon helps to remove heavier hydrocarbons, resins, and asphaltenes. This high-performance activated carbon also removes H2S, mercaptans and other sulfur bodies providing increased value.
ACTIVATED CARBON largest stockist near by you in Fujairah Sharjah Dubai Abudhabi, Muscat, Ruwi Barka Sohar Oman
#ActivatedCARBON
#ACTIVATEDcarbon_supplierFujairahDubaiAjmanAbudhabiMuscatOman
Dosage and directions
Characteristics and notes
ACTIVATED CARBON It is known that removal of impurities from liquids or gases by Activated Carbon is by adsorption. But only a thin layer if molecules is enough to neutralize the residual attraction of the outer carbon atoms, which then cannot be adsorb any further molecules and carbon is said to be exhausted. It is however possible to make carbon porous. In this way many countless are created and internal surface area is increased. Many more carbon atoms are then exposed to the surroundings resulted in more molecules from surroundings can be attracted. The carbon is more active and hence called “Activated Carbon”. One gram of ground carbon has an external surface area of 2 to 4 square meters, whereas when carbon has been activated this one gram of carbon may acquire an internal surface area of more one thousand square meters.
PRODUCTION OF ACTIVATED CARBON Activated carbon can be produced from many raw materials i.e. Soft wood, Coconut shell, Peat lignite (Both mineral & coal). The raw material must be relatively low cost and source of raw material should be closed to the factory location to minimize the transport cost. We are using Soft wood & Coconut shell charcoal as raw material in our factory.
PROCESS OF MANUFACTURING:
1. STEAM ACTIVATED PROCESS: The majority of Activated Carbon used through out the world is produced by two stage process. Firstly the material is carbonized and cock is produced. The pores of produced cock are too small; hence, the next is a process of enlarging the pore structure so that an accessible internal surface is created. This is achieved by semi product with steam at temperature between 900o C to 1200o C. At this temperature rate determination factor is the chemical reaction between steam and carbon. This reaction takes place at the internal surface of the carbon removing carbon from the pore walls and there by enlarging them. Opening up the pore structure is costly as the yield decreases and extra heat is required. e.g. In the purification of water for the adsorption of small molecules from solution. This carbon is cheaper compare to sugar decolorizing carbon where large molecules are to be removed. Thus, steam activation process allows the pore size to be altered and finally carbon can be made to suit different purpose.
PRODUCT The product range of our company can be broadly divided in two categories that is -Powder Carbon & Granular Carbon. Activated carbons are produced from selected best quality of wood charcoal to give a high quality product.
POWDER CARBON:
a. Oil Grade Carbons: We have wide range of different grade of Activated carbon for bleaching of edible oils like G.N., Solvent extracted G.N. Oil, Cotton seed Oil, Rapeseed Oil, Soya bean Oil, Palm Oil, Rice bran Oil, Maize Oil, etc. as well as non edible oil like castor oil & mineral oil.
b. Carbon for Purification Of Sugar & Related Products: Activated Carbon for purification of sugar syrups, refining of glucose, dextrose & in manufacture of sugar cubs.
c. Carbon for Purification of Chemicals: For purification of chemicals Dye Intermediates, Electroplating bath solution, plasticizers EDTA, And Acetic acid etc.
Safety and SDS
Read the safety data sheet before handling. Wear suitable gloves and eye protection.
View safety data sheet
| Product Name | RXSOL-26-3107-055 |
| Product Type | Activated Carbon |
Company Details:
RX MARINE INTERNATIONAL
105, A wing, BSEL, TECH PARK.
VASHI, NEW BOMBAY 400703 INDIA
Stock Point : Mumbai, Kandla, Kolkata, Chennai, Vizag, Fujairah, Muscat
| Phone | +91 22 65113333 / 5555 / 9999 / 27611360 |
| Fax | +91 22 2781 1318 :::AOH :0091 9821214367 |
| rxsolchemicals@gmail.com |
INGREDIENTS.
Chemical Name (CAS) % PEL(OSHA) TLV(ACGIH) Other
Carbon (7440-44-0) 100 N/A N/A N/A
*ACGIH (TWA) for reparable dust is 2.5 mg/m3
There are no established PEL, TWA or TLV values for this material. Caution should be taken for respirable dust. The product has no known carcinogenic properties.
HEALTH HAZARD DATA:
Route (s) of Entry:
Ingestion: Carbon is non-toxic through ingestion
Inhalation: The physical nature of carbon may irritate the respiratory system
Skin: Carbon is non-toxic through skin absorption.
Eye Irritation: The physical nature of carbon may cause, eye irritation.
EMERGENCY & EIRST AID PROCEDURES:
In case of inhalation remove to fresh air. Administer first aid as appropriate. Seek medical attention.
In ease off ingestion do not induce vomiting. Dilute by giving water or milk. Seek medical attention.
Skin Contact: Wash thoroughly with water. If irritation persists seek medical attention.
In case of eye contact flush with lukewarm water for at least 15 minutes. Seek medical attention.
OTHER:
The effects of chronic and sub-chronic exposure have not been determined. Safe handling on a long-term basis should emphasize
protection against respective or long-term exposure to carbon dust inhalation and avoidance of contact to any liquids that may Leach off the impregnated carbon.
FIRE FIGHTING MEASURES
Flashpoint: Not Applicable.
Non-flammable: 16CFR1500.44.
Not Self Heating: UN Manual of Tests and Criteria, Test N.3.
Flammability Limits in Air: LFL and UFL Not Applicable.
GENERAL HAZARD:
Activated carbon is difficult to ignite and tends to burn slowly (smoulder) without producing smoke or flame. Toxic gases will form upon combustion.
FIRE FIGHTING INSTRUCTIONS:
If possible to do safely, move smouldering activated carbon to a non-hazardous area, preferably out of doors. Extinguish fire using water fog, fine water spray, carbon dioxide or foam. Avoid stirring up dust clouds.
FIRE FIGHTING EQUIPMENT:
Firefighting personnel should wear full protective equipment, including self-contained breathing apparatus (SCBA) for all inside fires and large outdoor fires.
HAZARDOUS COMBUSTION PRODUCTS:
Combustion products may include smoke and oxides of carbon (for example, carbon monoxide). Materials allowed to smolder for long periods in enclosed spaces may produce amounts of carbon monoxide which reach the lower explosive limit (carbon monoxide LEL = 12.5% in air). Under certain conditions, any airborne dust may be an explosion hazard. Used activated carbon may produce additional combustion products.
Fire Explosion Data
Flash Point: N/A
Extinguishing media: Alcohol foam, CO2, dry chemical, water.
Special Firefighting procedures: Exercise caution when responding to any chemical fire. Respiratory Protection is essential
Unusual fire & explosion hazards: Contact of activated carbon with strong oxidizers may cause rapid combustion.
Contact of Phosphoric acid with certain metals may liberate hydrogen which is
flammable and readily forms explosive mixtures in air.
Decomposition Products: CO may be formed in the fire.
Thermal Decomposition: Sulfur Oxides (SOx)
STORAGE AND HANDLING INFORMATION:
Storage Temperature: Ambient
Storage Pressure: Atmospheric
Handling: Follow good handling and housekeeping practices to minimize spills, generation of airborne dust, and accumulation of dust on exposed surfaces.
Use with adequate exhaust ventilation to draw dust away from workers' breathing zones.
Prevent or minimize exposures to dust by using appropriate personal protective equipment.
Wash exposed skin areas thoroughly with soap and water after handling.
Storage: Dry airtight storage recommended. Maintain good housekeeping. Store away from strong oxidizers such as ozone, liquid oxygen, chlorine, permanganate, etc.
SPECIAL PROTECTION INFORMATION:
Respiratory Protection: Use NIOSH/MSHA approved respiratory protection equipment appropriate to the material
and/or its concentration where airborne exposure is likely. If exposures cannot be kept to a minimum with engineering controls,
consult respirator manufacturer to determine appropriate type equipment for a given application. Observe respirator use limitations
specified by NIOSH/MSHA or the manufacturer.
Ventilation/Local Exhaust: Essential in confined areas.
Eye Protection: Safety glasses or goggles with side shields are recommended for any type of handling. Where
eye contact or dusty conditions may be likely, dust tight goggles are recommended. Have eye flushing equipment available.
Engineering Controls: Use local exhaust ventilation to control emissions near the source. Ventilation systems should be sized and configured to prevent exceeding of recommended or regulated exposure limits. Skin Protection: Avoid contact with the skin. Wear appropriate dust resistant clothing. Wash contaminated
clothing and clean protective equipment before reuse. Wash skin thoroughly after handling. Protective Gloves Recommended
Hygienic Practices: Wash thoroughly after handling.
Airborne Exposure Guidelines:
Recommended Exposure Limits Activated Carbon
8-hr TWA
Total Dust 10 mg/m3*
Respirable Fraction 3 mg/m3*
*OSHA and ACGIH have not established specific exposure limits for this material. The recommended exposure limits for these
activated carbon products are base on the Threshold Limit Values adopted by ACGIH for Particulates (insoluble) Not Otherwise
Classified. The OSHA PEL for Nuisance Dust is 15 mg/m3 (5 mg/m3 respirable fraction).
PHYSICAL DATA:
Specific Gravity, (H2O = 1): 3.5
Solubility in water: Insoluble
Apparent Density: 0.45 - 0.50 g/cc
Vapor Pressure: N/A
Melting Point: N/A
Boiling Point: N/A
Freezing Point: N/A
Appearance and Odor: Black granular, powder or extruded pellet, no odor
Incompatibility. Avoid strong oxidizers and liquid acids.
Stable: Yes
Conditions to avoid: None
Hazardous Decomposition Products: Oxides of Carbon
Hazardous Polymerization: Will not occur
ECOLOGICAL AND TOXICOLOGICAL INFORMATION
This material, in its original state, is not harmful to the environment. Used activated carbon may exhibit characteristics of the
adsorbed material.
This material is non-toxic in its original state. Used activated carbon may exhibit characteristics of the adsorbed material.
OSHA Hazard Communication: See "Particulates not otherwise regulated," in Table Z-1, Standard, 29CFR1910.1200:of 29CFR1910.1000, "Limits For Air Contaminates".
CERCLA/SUPERFUND, 40CFR117, 302: Notification of spills of this material is not required.
SARA/SUPERFUND: Amendments and Reauthorization Act of 1986 (Title III), Sections 302, and 313:.
SECTION 302 - EXTREMELY HAZARDOUS SUBSTANCES (40CFR355):
This product is not listed as an extremely hazardous substance.
SECTION 313 - LIST OF TOXIC CHEMICALS: This product is not listed.
Toxic Substances Control Act, 40CFR710: Activated carbon is on the inventory list.
Resource Conservation and Recovery Act: This product, in its original state, does not meet the criteria of hazardous waste.
STATE REGULATIONS:
California Occupational Safety and Health: • Not listed.
Massachusetts Substance List: • Not listed.
New Jersey Right-to-Know: • Not listed.
Pennsylvania Right-to-Know: • Not listed.
HMIS INDEX:
HMIS Index details are as follows,
HEALTH: 0
FLAMMABILITY: 1
REACTIVITY: 1
PPE: E
Proper Shipping (Article) Name: Steam Activated Carbon, Non-Regulated OR Carbon, Activated, Non-Regulated
Shipping Class: Class 70
Hazard Class: Not applicable.
UN/NA Number: Not applicable.
Packing Group: Not applicable.
Freight Classification: STCC Code - #2899643 / NMFC #040560
DOT Marking: N/A
DOT Placard: N/A
Precautions to be taken in Transportation: N/A
in handling and storage: Avoid excessive contact with moisture.Activated carbon can be safely stored in any normal storage area, but away from sources of direct heat.
Other precautions: Wet activated carbon depletes oxygen from the air creating a severe hazard to workers in enclosed or confined spaces, sampling and work procedures for low oxygen levels should be taken whenever workers entering carbon vessels, enclosed or confined spaces.
KEEP OUT OF REACH OF CHILDREN
Although the information and recommendations set forth in this sheet are believed to be correct as of the date hereof, RX MARINE International.
makes no representation as to the completeness or accuracy of such information and recommendations. RX MARINE International. shall in no event be responsible for any damages of whatsoever nature directly or indirectly resulting from the publication or use of or reliance
upon such information and recommendations. You are encouraged to advise anyone working with or exposed to such products of the information
contained herein. No Warranty, either expressed or implied, of merchantability or fitness or of any other nature with respect to the product or to the information and recommendations herein made hereunder.
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.
Availability
Activated Carbon Powdered manufacturer supplier distributor in Mumbai, Kandla, Kolkata, Vizag, Chennai, India, Fujairah, Dubai, Sharjah, UAE, Gulf, Middle East, Muscat Oman, Kenya Africa. Get the best quality of Activated Carbon Powdered at a competitive price from us. We have ready stock of Activated Carbon Powdered in India, UAE Gulf, Oman, Kenya Africa. Contact us for bulk as well as small orders.
