RXSOL ORG - 6
- Part number
- RXSOL-20-2059-210
- Category
- Tank Cleaner
- Brand
- RXSOL
Overview
POLYMER Sludge Emulsification is directly depends on sludge molecule nature and its bonding strength. Breaking of intermolecular bond becomes very easy by knowing cargo nature and property. Our RX representative can help to adopt easiest process by analysing slugde chemicals property in our LAB.
RXSOL-20-2059-210 can be use as a all purpose degreaser for cleaning of Oil and Sludge with emulsifiers. It is an excellent blend of powerful solvent base and emulsifying inorganic products .Specially designed for engine room and cargo tank cleaning .Main feature of RXSOL-20-2006-210 is, it finally dissociate slop emulsion to separate oil and water .This provide us with ability to dispose of waste solution as per MARPOL & IMO rules and regulation
Technical specifications
|||
| Clear (Raw material depended colour of the effectively will , however not be impaired .) | |
| In g/cm3 at 15°C | 1.1 |
|---|---|
| (PMCC)°C | Above 88 |
Applications
Oil and Sludge remover
Dosage and directions
Dosage:- Dose rate and results will vary depending on amount of contamination . For light contamination dilution with water up to 1:20 is recommended, where as medium contamination dilute 1:10, And for heavy contamination neat RXSOL-20-2059-210 is suggested to use.
Procedure of use :- RXSOL-20-2059-210 is also recommended for local cleaning & degreasing of engine rooms, bilges & tank tops. It may be applied by brush, spray, immersion, soaking, or any other conventional means.RXSOL-20-2059-210 is used neat. Allow a residence time of at least 20- 45 minutes where possible, to ensure good penetration & emulsification. Finally wash the system with hot water & high pressure.The emulsion residue after cleaning must be allowed to separate in a holding tank for atleast 3-5 hours before passing through an oily water separator.
Tank Cleaning Sludge/ Lube Oils / Slope-Black Oil
1 ) Fill the tank with 1-35 litres per ton wash water.Best results are obtained when water is heated to a temperature between 65°C & 80°C then stripped constantly and transferred to a holding tank for separation.The time for this will vary depending on amount of RXSOL-20-2059-210 used & nature of oil being cleaned.Generally,12 hours should be sufficient before the water phase can be removed.
2) Direct Cleaning ::: For Heavy deposition spray directly RXSOL-20-2059-210 on tank surfaces to be cleaned, left for at least 30 minutes.Finally wash with hydrogating (high pressure) machine. Hot water between 50°C & 80°C recommended.
Characteristics and notes
Characteristics:-
High penetration & emulsification , Reduces down time.
Low toxicity, non -corrosive. Highly effective, economical solvent cleaner.
For cleaning of machinery parts, bulk heads, decks, bottom plates & any oil/grease dirty areas.
Used for cargo tank cleaning of mineral oils and petroleum based chemicals, Sludge etc .
Safety and SDS
Read the safety data sheet before handling. Wear suitable gloves and eye protection.
View safety data sheet
| Product Name | RXSOL ORG -6 |
| Product Type | Oil & Sludge Remover |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
| Phone |
+91 22 65113333 +91 22 65113333 / 5555 / 9999 / 27611360 |
| Fax |
+91 22 2781 1318+91 22 2781 1318 :::AOH :0091 98212143670091 9821214367 |
| rxsolchemicals@gmail.com |
|
Chemical Name |
Concentration |
CAS Number |
EC Number |
R Phrases* |
Symbols |
|
Polymer With White spirit (de-aromatized) |
20-40 |
64742-48-9 |
265-150-3 |
65,66 |
Xn |
|
Sodium sulphonate |
5-10 |
68608-26-4 |
271-781-5 |
36 |
Xi |
Other ingrident not classified as dangerous.
|
Odour |
Charastic |
|
Appearance |
Liquid, Pale Light yellow |
|
Contact with eyes |
Causes redness and irritation. |
|
Contact with skin |
Prolonged skin contact will result in defatting of the skin, leading to irritation, and in some cases, dermatitis. |
|
Inhalation |
In cases of severe exposure, anaesthesia may develop, May cause chronic pneumonitis, May cause coughing. |
|
Ingestion |
Harmful: may cause lung damage if swallowed (R65), The ingestion of significant quantities.may cause nausea/vomiting. |
|
Contact with skin |
Remove contaminated clothing immediately and drench affected skin with plenty of water Contaminated clothing should be laundered before reuse Seek medical attention if irritation persists. |
|
Contact with eyes |
If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes Irrigate eyes thoroughly whilst lifting eyelids When in doubt or symptoms persist, seek medical attention. |
|
Ingestion |
Do not induce vomiting because of risk of aspiration into the lungs. If aspiration is suspected obtain immediate medical attention If vomiting occurs turn patient on side Obtain immediate medical attention. |
|
Inhalation |
Remove patient to fresh air Seek medical attention if ill effects occur. |
|
General |
In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible) (S45). |
on dilution ::: NON Flammable
- Auto-ignition point 225 deg C at 760 mm Hg
- Flash point 78 deg C (CC)
- Decomposition products may include carbon oxides
- In case of fire use water spray or fog, alcohol resistant foam, dry chemical or carbon dioxide (S43)
- Do not use water jets
- Prevent run off water from entering drains if possible
- Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback
|
Personal Precautions |
Wear protective clothing as per section 8. |
|
Environmental Precautions |
Do not allow to enter public sewers and watercourses. |
|
Immediate Actions |
Contain spillage by any means possible. |
|
Clean Up Actions |
Absorb spillage in inert material and shovel up Ventilate the area and wash spill site after material pick-up is complete. |
|
Special Precautions |
Do not allow to enter public sewers and watercourses Wear protective clothing as per section 8. |
|
Handling |
Avoid contact with skin and eyes .Eyewash bottles should be available See Section 8. |
|
Storage |
Keep only in the original container in a cool, well ventilated place (S3/9/49) Keep container tightly closed (S7) Keep away from open flames, hot surfaces and sources of ignition. |
|
Exposure Limits |
TLV (TWA) 275 mg/m3 |
|
Exposure controls |
No special ventilation is required unless the product is used in a spray form. |
|
Occupational exposure controls |
No respiratory protection is required unless subject to contact with substance mist During fumigation/spraying wear suitable respiratory equipment (S42) Wear suitable protective clothing, including eye/face protection and gloves (neoprene or nitrile are recommended). |
|
Odour |
Charastic |
|
Appearance |
Liquid, Pale golden Yellow |
|
pH |
neutral |
|
Boiling point |
195 °C at 760 mm /Hg |
|
Vapour pressure |
1 mbar |
|
Vapour density |
(air = 1) >1 |
|
viscocity at 20 deg C (CC) |
10 MPAS |
|
Insoluble in water |
Specific gravity /(water=1) 0.91 |
|
Flash point |
above 78 deg C (CC) |
|
Auto-ignition point |
225 deg C at 760 mm Hg |
|
Lower explosive limit |
0.2 % (in air) |
- This article is considered stable under normal conditions
- Keep away from naked flames, incandescent or hot surfaces
- See Section 5
HAZARD : Non Toxic
|
Toxicological information |
No experimental data available. |
|
Inhalation |
Inhalation of solvent vapours may give rise to nausea, headaches and dizziness. |
|
Contact with skin |
Prolonged skin contact will result in defatting of the skin, leading to irritation, and in some cases, dermatitis. |
|
Contact with eyes |
May cause redness and irritation. |
|
Ingestion |
The ingestion of significant quantities may cause gastro-intestinal disturbances Aspiration hazard. |
|
Carcinogenicity |
No evidence of carcinogenic effects. |
|
Ecotoxicity |
This product has been evaluated on its behaviour in the environment by "The TNO Institue of Environmental Sciences" (The Netherlands organisation for applied Scientific Research). Based upon their report, IMO's BCH Working Group on the Evaluation of Safety and Pollution Hazards approved this product for use as tank cleaning agent by chemical tankers. Naphtha : LC50 (fish) >100 mg/l (96 hr). EC50 (daphnia) >100 mg/l (72 hr). IC50 (algae) >100 mg/l (72 hr) |
|
Mobility |
soluble in water |
|
Bioaccumulation Potential |
No information available |
|
Other Adverse Effects |
No environmental problems are expected when the product is used / handled correctly. In its intended use, the product will not be released into the environment. |
|
Disposal considerations |
Do not discharge into drains or the environment, dispose to an authorised waste collection point Disposal should be in accordance with local, state or national legislation |
- Not classified as hazardous for transport
|
Risk Phrases |
Irriant: may cause lung damage if swallowed (R65).Repeated exposure may cause skin dryness or cracking (R66) |
|
Safety Phrases |
Do not breathe spray/mists (S23) Wear suitable protective clothing, eye/face protection and gloves (S36/37/39) If swallowed, do not induce vomiting: seek medical advice immediately and show this container or label (S62). |
Text of R and S phrase codes used in this safety data sheet:- R36: Irritating to eyes; R65: Harmful: may cause lung damage if swallowed; R66: Repeated exposure may cause skin dryness or cracking.The information provided about the product on this Safety Data Sheet has been compiled from knowledge of the individual constituents The data given here is based on current knowledge and experience. This Safety Data Sheet describes the product in terms of safety requirements and does not signify any warranty with regard to the product's properties The data given here only applies when product used for proper application(s). The product is not sold as suitable for other applications - usage in such may cause risks not mentioned in this sheet. Do not use for other application(s) without seeking advice from manufacturer.
Anionic surfactants 5-15 %
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.
Availability
All purpose polymer based degreaser for cleaning of Oil and Sludge with emulsifiers. It is an excellent blend of powerful solvent base and emulsifying inorganic products .Specially designed for engine room and cargo tank cleaning .Main feature of RXSOL- manufacturer supplier distributor in Mumbai, Kandla, Kolkata, Vizag, Chennai, India, Fujairah, Dubai UAE, Muscat Oman, Kenya Africa. Get the best quality of All purpose polymer based degreaser for cleaning of Oil and Sludge with emulsifiers. It is an excellent blend of powerful solvent base and emulsifying inorganic products .Specially designed for engine room and cargo tank cleaning .Main feature of RXSOL- at a competitive price from us. We have ready stock of All purpose polymer based degreaser for cleaning of Oil and Sludge with emulsifiers. It is an excellent blend of powerful solvent base and emulsifying inorganic products .Specially designed for engine room and cargo tank cleaning .Main feature of RXSOL- in India, UAE Gulf, Oman, Kenya Africa. Contact us for bulk as well as small orders.
