RXSOL Zyme MSD Bio
- Part number
- RXSOL-15-1546-020
- Category
- House / HOTEL & CATERING
- Brand
- RXSOL
Overview
RXSOL Zyme MSD Bio is a concentrated biologically active powder formulation containing a blend of patented bacterial strains, specifically developed to deal with sewage wastes. It is packed as water soluble sachets (Solupac).
RXSOL-15-1546-020 is formulated to degrade excess residual organic waste products causing blockage, or slow draining in sinks, showers, scuppers, drains, etc. The specialised bacterial strains and enzymes in RXSOL-15-1546-020 will digest grease, fats, starch and other organic compounds. The bacteria in RXSOL-15-1546-020 will colonise the waste soil, which lines the pipe work system, and degrade the waste all the way down to carbon dioxide and water, until the system is clean. On draining to the holding tank or sewage treatment plant, RXSOL-15-1546-020 will greatly enhance the biological activity breaking down solids and removing obnoxious odours which can vent back through the systems.
Applications
Product Specifications
Packing, Type PLASTIC
Colour TAN
Appearance SAW DUST LIKE POWDER
Directions for use
Pipe cleaning
Maintenance dosing will keep sinks, scuppers and waste food disposal units clean, clear and odour free. A liquid solution should be prepared by adding one solupac to 10 litres of hand hot (35°C) fresh water and left for 15 minutes (stirring periodically) for the bacteria to activate. Initial doses of 0.5 litres of this solution should be applied into sinks, scuppers, drains, waste food disposal units, etc. A maintenance dose once or twice a week can then be applied to keep the pipes in clean condition. Harsh toxic cleaners (acids, caustics, disinfectants) should not be used as these will kill off the bacterial action in the pipes. Before plumbing work for pipe modification or retrofits, pipes can be cleaned by isolating the system and filling pipes with the solution for up to 48 hours before draining. If necessary, further applications should be made until drains run clean.
Holding tanks
Organic wastes can be kept liquid and pumpable. Tanks can be cleaned without manual entry and without the use of harsh toxic cleaning chemicals. Prepare a solution of one solupac to ten litres of hand hot (35°C) fresh water and left for 15 minutes (stirring periodically) before dosing into the holding tank once or twice a week. The dose rates should be approximately one solupac per 1000 litre waste in the tank. Tank cleaning should be carried out using RXSOL-15-1546-020
Characteristics and notes
NOTE: Severely scaled systems should be acid cleaned.
Features
• Powder biological formulation for easy use.
• Biodegradable.
• Clears pipes and systems blocked by organic waste residuals.
• Eliminates obnoxious odours from soiled pipe lines.
• Cleans fouled pipes and systems, particularly long horizontal runs.
• Keeps holding tank organic waste liquid pumpable and odour free.
• Cost effective, saves the time, money and manpower of plumbing operations to clear blocked pipe work.
• Overcomes potential safety problems associated with the use of toxic cleaning chemicals.
Safety and SDS
Read the safety data sheet before handling. Wear suitable gloves and eye protection.
View safety data sheet
|
Product Name |
RXSOL-15-1546-020 |
|
Product Type |
RXSOL Zyme MSD Bio |
| Revised Date | 20-04-2019 |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
BRANCH Stock point : Kandla, Mumbai, CHENNAI, Visakhapatnam, Kolkata, Fujairah
| Phone | +91 22 27815541 / 42 |
| Fax | +91 22 2781 1318 :::AOH :0091 9821214367 |
| rxsolchemicals@gmail.com |
|
Chemical Name |
Concentration |
CAS Number |
EC Number |
R Phrases* |
Symbols Disodium |
|
Viable bacterial cultures |
5-10 |
N/A |
N/A |
- |
- |
|
Other non classified ingredients |
5-10 % |
60-100 |
- |
- |
- |
*See Section 16
|
Odour |
Characteristic odour |
|
Appearance |
fibres, tan, partly soluble in water |
|
Contact with eyes |
Prolonged exposure may cause abrasive irritation of the eyes |
|
Contact with skin |
In cases of severe exposure, irritation may develop |
|
Inhalation |
Prolonged exposure may cause abrasive irritation of the mucous membranes |
|
Ingestion |
The ingestion of significant quantities may cause gastro-intestinal disturbances |
|
Contact with skin |
Remove contaminated clothing immediately and drench affected skin with plenty of water. Then wash with soap and water.When in doubt or symptoms persist, seek medical attention |
|
Contact with eyes |
If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes Irrigate eyes thoroughly whilst lifting eyelids.When in doubt or symptoms persist, seek medical attention |
|
Ingestion |
Never give anything by mouth to an unconscious person. Give plenty of water to drink. Seek medical attention if ill effects occur |
|
Inhalation |
Remove patient to fresh air. Keep warm and at rest, in a half upright position. Loosen clothing.Seek medical attention if ill effects occur |
|
General |
In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible) (S45) |
Combustible
Carbon oxides may be formed
In case of fire use water, alcohol resistant foam, carbon dioxide or dry agent (S43)
| Personal Precautions |
| Wear protective clothing as per section 8 |
| Environmental Precautions |
| No special precautions are required for this product |
| Clean Up Actions |
| Sweep or shovel-up spillage and remove to a safe place |
| Ventilate the area and wash spill site after material pick-up is complete |
| Special Precautions |
| No special precautions are required for this product |
|
Handling |
The usual precautions for handling chemicals should be observed |
|
Storage |
Keep only in the original container in a cool, well ventilated place (S3/9/49) |
|
Exposure Limits |
There are no recommended or established controls for this product |
|
Exposure controls |
No special precautions are required for this product |
|
Occupational exposure controls |
Wear suitable protective clothing, including eye/face protection and gloves (plastic or rubber are recommended) |
|
Odour |
Characteristic odour |
|
Appearance |
fibres, tan, partly soluble in water |
|
pH |
~ 7 at 1 % concentration |
|
Boiling point |
not applicable |
|
Vapour pressure |
not known |
|
Melting point |
not applicable |
|
Dispersible |
|
|
Density |
700 kg/m3 |
|
Combustible |
Stable
Avoid overheating, Avoid contact with acids and alkalis
Incompatible with acids and alkalis, Incompatible with oxidizing substances
See Section 5
|
Stable |
Avoid overheating, Avoid contact with acids and alkalis.Incompatible with acids and alkalis, Incompatible with oxidizing substances. |
|
Contact with skin |
In cases of severe exposure, redness and irritation may develop. |
|
Contact with eyes |
May cause irritation. |
|
Ingestion |
The ingestion of significant quantities may cause gastro-intestinal disturbances. |
|
Carcinogenicity |
No evidence of carcinogenic effects. |
|
Ecotoxicity |
This can be considered as an environmentally friendly product. |
|
Mobility |
Dispersible |
|
Persistence and Biodegradability |
The components in this product are readily biodegradable. |
|
Bioaccumulation Potential |
Bioaccumulation of the components in this product is insignificant. |
|
Other Adverse Effects |
Presents no hazard to the environment |
|
Classification |
EU Waste class: - |
|
Disposal considerations |
No special precautions are required for this product |
Not classified as hazardous for transport
|
Classification and labelling |
Not classified as hazardous for supply |
|
Risk Phrases |
Not applicable |
|
Safety Phrases |
Not applicable |
The information provided about the product on this Safety Data Sheet has been compiled from knowledge of
the individual constituents The data given here is based on current knowledge and experience. This Safety Data Sheet describes the product in terms of safety requirements and does not signify any warranty with regard to the product's properties The data given here only applies when product used for proper application(s). The product is not sold as suitable for other applications - usage in such may cause risks not mentioned in this sheet. Do not use for other
application(s) without seeking advice from manufacturer This Safety Data Sheet is provided in compliance with The Dangerous Substances Directive (67/548/EEC) This Safety Data Sheet is provided in compliance with The Dangerous Preparations Directive (88/379/EEC) This Safety Data Sheet is provided in compliance with The Safety Data Sheets Directive (2001/58EC)
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.
Availability
RXSOL Zyme MSD Bio manufacturer supplier distributor in Mumbai, Kandla, Kolkata, Vizag, Chennai, India, Fujairah, Dubai UAE, Muscat Oman, Kenya Africa. Get the best quality of RXSOL Zyme MSD Bio at a competitive price from us. We have ready stock of RXSOL Zyme MSD Bio in India, UAE Gulf, Oman, Kenya Africa. Contact us for bulk as well as small orders.
