Solvent Clean

Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA

HAZARDOUS INGREDIENTS:                                  OSHA             PEL TLV
Odorless Mineral Spirits (CAS# 64742-48-9)             300 ppm           N/D
Glycol Ether DPM (CAS# 34590-94-8 )                      100 ppm         100 ppm

POTENTIAL PHYSICAL / CHEMICAL EFFECTS
Combustible. Material can release vapors that readily form flammable mixtures. Vapor accumulation could flash and/or explode if ignited. Material can accumulate static charges which may cause an incendiary electrical discharge.
POTENTIAL HEALTH EFFECTS
Repeated exposure may cause skin dryness or cracking. If swallowed, may be aspirated and cause lung damage. May be irritating to the eyes, nose, throat, and lungs.
ENVIRONMENTAL HAZARDS
May cause long-term adverse effects in the aquatic environment.
NOTE: This material should not be used for any other purpose than the intended use in Section 1 without expert advice. Health studies have shown that chemical exposure may cause potential human health risks which may vary from person to person.

INHALATION
Remove from further exposure. For those providing assistance, avoid exposure to yourself or others. Use adequate respiratory protection. If respiratory irritation, dizziness, nausea, or unconsciousness occurs, seek immediate medical assistance. If breathing has stopped, assist ventilation with a mechanical device or use mouth-to-mouth resuscitation.
SKIN CONTACT
Wash contact areas with soap and water. Remove contaminated clothing. Launder contaminated clothing before reuse.
EYE CONTACT
Flush thoroughly with water. If irritation occurs, get medical assistance.
INGESTION
Seek immediate medical attention. Do not induce vomiting.
NOTE TO PHYSICIAN
If ingested, material may be aspirated into the lungs and cause chemical pneumonitis. Treat appropriately.

FLAMMABILITY PROPERTIES
Flash Point :137º F
EXTINGUISHING MEDIA
Appropriate Extinguishing Media: Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.
Inappropriate Extinguishing Media: Straight Streams of Water
FIRE FIGHTING
Fire Fighting Instructions: Evacuate area. Prevent runoff from fire control or dilution from entering streams, sewers, or drinking water supply. Firefighters should use standard protective equipment and in enclosed spaces, self-contained breathing apparatus (SCBA). Use water spray to cool fire exposed surfaces and to protect personnel.
Unusual Fire Hazards: Vapors are flammable and heavier than air. Vapors may travel across the ground and reach remote ignition sources causing a flashback fire danger. Hazardous material.
Firefighters should consider protective equipment indicated in Section 8.
Hazardous Combustion Products: Incomplete combustion products, Oxides of carbon, Smoke, Fume
 

ROTECTIVE MEASURES
Avoid contact with spilled material. Warn or evacuate occupants in surrounding and downwind areas if required due to toxicity or flammability of the material. See Section 5 for fire fighting information. See the Hazard Identification Section for Significant Hazards. See Section 4 for First Aid Advice. See Section 8 for Personal Protective Equipment.
SPILL MANAGEMENT
Do not touch or walk through spilled material. Prevent entry into waterways, sewers, basements or confined areas. Use clean non-sparking tools to collect absorbed material. Absorb or cover with dry earth, sand or other non-combustible material and transfer to containers.

HANDLING
Avoid contact with skin. Prevent small spills and leakage to avoid slip hazard. Material can accumulate static charges which may cause an electrical spark (ignition source). Static Accumulator: This material is a static accumulator.
STORAGE
Keep container closed. Handle containers with care. Open slowly in order to control possible pressure release. Store in a cool, well-ventilated area.

ENGINEERING CONTROLS
The level of protection and types of controls necessary will vary depending upon potential exposure conditions. Control measures to consider: Adequate ventilation should be provided so that exposure limits are not exceeded. Use explosion-proof ventilation equipment.
PERSONAL PROTECTION
Personal protective equipment selections vary based on potential exposure conditions such as applications, handling practices, concentration and ventilation. Information on the selection of protective equipment for use with this material, as provided below, is based upon intended, normal usage.
Respiratory Protection: If engineering controls do not maintain airborne contaminant concentrations at a level which is adequate to protect worker health, an approved respirator may be appropriate. Respirator selection, use, and maintenance must be in accordance with regulatory requirements, if applicable. Types of respirators to be considered for this material include: Half-face filter respirator.
Hand Protection: The types of gloves to be considered for this material include:
If prolonged or repeated contact is likely, chemical resistant gloves are recommended. If contact with forearms is likely, wear gauntlet style gloves.
Eye Protection: If contact is likely, safety glasses with side shields are recommended.
Skin and Body Protection: If prolonged or repeated contact is likely, chemical, and oil resistant clothing is recommended.
Specific Hygiene Measures: Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Discard contaminated clothing and footwear that cannot be cleaned. Practice good housekeeping.

STABILITY: Material is stable under normal conditions.
CONDITIONS TO AVOID: Avoid heat, sparks, open flames and other ignition sources.
MATERIALS TO AVOID: Strong oxidizers
HAZARDOUS DECOMPOSITION PRODUCTS: Material does not decompose at ambient temperatures.
HAZARDOUS POLYMERIZATION: Will not occur.

Odorless Mineral Spirits
Acute Toxicity
Route of Exposure Conclusion / Remarks
Inhalation Toxicity: Data available. Minimally Toxic. Based on test data for the material.
Irritation: Data available. Negligible hazard at ambient/normal handling temperatures. Based on test data for structurally similar materials.
Ingestion
Toxicity: LD50 > 10000 mg/kg Minimally Toxic. Based on test data for the material.
Skin Toxicity: LD50 > 3160 mg/kg Minimally Toxic. Based on test data for the material.
Irritation: Data available. Mildly irritating to skin with prolonged exposure. Based on test data for the material.
Eye Irritation: Data available. May cause mild, short-lasting discomfort to eyes. Based on test data for the material.
Chronic/Other Effects
For the product itself: Vapor/aerosol concentrations above recommended exposure levels are irritating to the eyes and respiratory tract, may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness and other central nervous system effects including death. Prolonged and/or repeated skin contact with low viscosity materials may de-fat the skin resulting in possible irritation and dermatitis. Small amounts of liquid aspirated into the lungs during ingestion or from vomiting may cause chemical pneumonitis or pulmonary edema.
Glycol Ether DPM
Acute Toxicity
Ingestion LD50, Rat 5,135 mg/kg Skin Absorption LD50, Rabbit > 20 ml/kg
Inhalation LC50, 7 h, Aerosol, Rat > 500 ppm
Skin Sensitivity Did not cause allergic skin reactions when tested in humans

Odorless Mineral Spirits
ECOTOXICITY
Material : May cause long-term adverse effects in the aquatic environment.
PERSISTENCE AND DEGRADABILITY
Biodegradation: Material -- Expected to be readily biodegradable.
Hydrolysis: Material -- Transformation due to hydrolysis not expected to be significant.
Photolysis: Material -- Transformation due to photolysis not expected to be significant.
Atmospheric Oxidation: Material Expected to degrade rapidly in air.
Glycol Ether DPM
Material is readily biodegradable. Material is practicallynon-toxic to aquatic organisms
on an acute basis (LC50/EC50 >100 mg/L in the most sensitive species tested.

REGULATORY DISPOSAL INFORMATION
RCRA Information: Disposal of unused product may be subject to RCRA regulations (40 CFR 261). Disposal of the used product may also be regulated due to ignitability, corrosivity, reactivity or toxicity as determined by the Toxicity Characteristic Leaching Procedure (TCLP). Potential RCRA characteristics: IGNITABILITY. Empty Container Warning Empty Container Warning (where applicable): Empty containers may contain residue and can be dangerous. Do not attempt to refill or clean containers without proper instructions.
Do not dispose of on the land, in surface waters, or in storm drains. Spills of any quantity should be collected for reuse or consigned to a licensed hazardous waste hauler for disposal in accordance with federal, state and local regulations. All disposal must be in accordance with all federal, state and local regulations.

Ground Transportation: Limited quantity exception applies for inner packaging less than 1.3 gallons. Requires limited quantity label.
Air Transportation: With a vented seal/cap, this item cannot be shipped via air in accordance with CFR 49 173-24(g).
Maritime Transportation: UN1993; Flammable Liquid, NOS (Odorless Mineral Spirits); 3; PG III . Check regulation for limited quantity exceptions.

US Federal Regulations:
All components are listed on TSCA
CWA / OPA: This product is classified as an oil under Section 311 of the Clean Water Act (40 CFR 110) and the Oil Pollution Act of 1990. Discharge or spills which produce a visible sheen on either surface water, or in waterways/sewers which lead to surface water, must be reported to the
National Response Center at 800-424-8802.

This product has no established regulatory information. All regulatory information given is based on individual components of the mixture by component number. While this information and recommendations set forth herein are believed to be accurate and reliable, it is provided without warranty regarding its accuracy. BRIDGEPOINT SYSTEMS MAKES NO WARRANTY WITH RESPECT HERETO AND DISCLAIMS ALL LIABILITY FROM RELIANCE THEREON. Users must determine safe conditions for use and assume liability for any loss, injury, damage or expense resulting from use of this product.
N/A= Not applicable N/D= Not determined N/E= Not established