|
Porduct Name |
Trans12 DIAMINOCYCLOHEXANE NNNN TETRAACETIC ACID AR |
|
Part Number |
RXSOL-60-6605-750 |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Branch : Kandla, Mumbai , Chennai, Vizag, Kolkata, UAE , OMAN , CANADA and KENYA
|
Phone |
+91 22 20871200 - 1400 |
|
Fax |
+91 22 27612100 :::AOH :0091 9821214367 |
|
Email |
rxsolchemicals@gmail.com |
|
Website |
www.rxmraine.com |
|
Chemical Name |
Cas No |
Whight |
Formula |
|
Sodium arsenite, 0.1N Standardized Solution
|
7784-46-5 |
242,23 g/mol |
0.65 |
|
Signal Word |
Danger |
|
Classification of the substance or mixture |
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) |
|
Precautionary Statements Prevention |
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required |
|
Response |
IF exposed or concerned: Get medical attention/advice |
|
Storage |
Store locked up |
|
Disposal |
Dispose of contents/container to an approved waste disposal plant |
|
Hazards not otherwise classified (HNOC) |
Harmful to aquatic life with long lasting effects WARNING. Cancer - https://www.p65warnings.ca.gov/. |
|
General Advice |
If symptoms persist, call a physician |
|
Eye Contact |
Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Getmedical attention. |
|
Skin Contact |
Wash off immediately with plenty of water for at least 15 minutes. If skin irritationpersists,call a physician. |
|
Most important symptoms and effects, both acute and delaye |
None reasonably foreseeable. Notes to Physician Treat symptomatically |
|
Inhalation |
Remove to fresh air. If not breathing, give artificial respiration. Get medical attentionif symptoms occur. |
|
Ingestion |
Clean mouth with water and drink afterwards plenty of water |
|
Suitable extinguishing media |
Not combustible. |
|
Unsuitable extinguishing media |
No information available |
|
Specific Hazards Arising from the Chemical |
None reasonably foreseeable. |
|
Hazardous Combustion Products |
arsenic oxides. Sodium oxides. |
|
Protective Equipment and Precautions for Firefighters |
As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) andfull protective gear. |
|
Personal precautions, protective equipment and emergency procedures |
Ensure adequate ventilation. Use personal protective equipment as required. |
|
Enviromental Precaution |
Should not be released into the environment. See Section 12 for additional Ecological Information. Avoid release to the environment. Collect spillage. Do not flush intosurfacewater or sanitary sewer system. Do not allow material to contaminate ground water system |
Methods and materials for
containment and cleaning |
Soak up with inert absorbent material. Keep in suitable, closed containers for disposal |
|
Precautions for safe handling |
Wear personal protective equipment/face protection. Ensure adequate ventilation. Donot get in eyes, on skin, or on clothing. Avoid ingestion and inhalation. |
|
Storage |
Keep containers tightly closed in a dry, cool and well-ventilated place |
|
Eye/face protection |
Wear appropriate protective eyeglasses or chemical safety goggles as describedbyOSHA's eye and face protection regulations in 29 CFR 1910.133 or EuropeanStandardEN166. |
|
Respiratory protection |
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or EuropeanStandardEN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
|
|
Skin and body protection |
Wear appropriate protective gloves and clothing to prevent skin exposure |
|
Hygiene Measures |
Handle in accordance with good industrial hygiene and safety practice |
|
Physical state |
Liquid |
|
Appearance |
Colorless |
|
Odour |
Odorless |
|
Odor Threshold |
No information available |
|
pH |
No information available |
|
Melting Point |
No information available |
|
Boiling Point |
No information available |
|
Flash Point |
No information available |
|
Flammability (solid, gas) |
No data available |
|
Autoignition temperature |
No data available |
|
Decomposition temperature |
No data available |
|
Viscosity |
No information available |
|
Solubility |
No information available |
|
Reactivity |
None known, based on information available |
|
Chemical stability |
Stable under normal conditions. |
|
Possibility of hazardous reactions |
Violent reactions possible with: Strong oxidizing agents |
|
Conditions to avoid |
Incompatible products |
|
Incompatible materials |
Strong oxidizing agents |
|
Hazardous decomposition products |
Arsenic oxides, Sodium oxides |
|
Acute toxicity |
Based on ATE data, the classification criteria are not met. ATE > 2000 mg/kg. Based on ATE data, the classification criteria are not met. ATE > 2000 mg/kg. Based on ATE data, the classification criteria are not met. ATE > 20 mg/l. |
|
Skin corrosion/irritation |
No data available |
|
Respiratory or skin sensitization |
No information available |
|
Reproductive toxicity |
No data available |
|
Specific target organ toxicity - single exposure |
No data available
|
|
Additional Information |
RTECS: XP2071000 To the best of our knowledge, the chemical, physical, and toxicological properties have not been thoroughly investigated |
|
Persistence and degradability |
Based on information available. May persis |
|
Ecotoxicity |
Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment. The product contains followingsubstances which are hazardous for the environment. May cause long-term adverse effects in the environment. Do not allowmaterial to contaminate ground water system. |
|
Bioaccumulative potential |
No information available |
|
Mobility in Water |
Will likely be mobile in the environment due to its water solubility |
|
Endocrine disrupting properties |
No information available |
|
Other adverse effects |
No information available |
|
Waste Disposal Methods |
Chemical waste generators must determine whether a discarded chemical is classifiedasahazardous waste. Chemical waste generators must also consult local, regional, andnational hazardous waste regulations to ensure complete and accurate classification. |
|
UN number |
UN1686 |
|
UN proper shipping name |
SODIUM ARSENITE, AQUEOUS SOLUTIONS |
|
Transport hazard class(es) |
ADR/RID : - IMDG : - IATA : - |
|
Packaging group |
II |
|
Hazard Class |
6.1 |
|
Safety, health and environmental regulations/legislation specific for the substance or mixture |
This material safety data sheet complies with the requirements of Regulation (EC) No. 1907/2006. |
|
Chemical Safety Assessment |
For this product a chemical safety assessment was not carried out |
|
Other Information |
The information above is believed to be accurate and represents the best information currently available to us. However, we make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and weassume no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for their particular purposes. In no event shall be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if Rx Marine International has been advised of the possibility of such damages.
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.
|
