RXSOL CHEMO PHARMA International Navi Mumbai, India

Products

7,087 products across 101 categories for marine, industrial, water treatment and laboratory use.

Browse all products Product catalogue

Cooling Water Chemical

Biocide 7000

Titanium dioxide Based Biocide Biocide 7000 is a broad spectrum liquid microbiocide for use in a variety of water treatment applications, including open and closed recirculating cooling systems, paper mills, air washers and non-potable water storage
Part number
RXSOL-41-8999-025
Brand
RXSOL
Biocide 7000

Overview

Biocide 7000 is a broad spectrum liquid microbiocide for use in a variety of water treatment applications, including open and closed recirculating cooling systems, paper mills, air washers and non-potable water storage. Biocide 7000 causes immediate inhibition of growth on coming in contact with micro-organisms.

It controls a wide variety of algae, bacteria and fungi found in industrial water systems. Effective control of such a wide variety of micro-organisms is achieved at low concentrations, which makes 
Biocide 7000 is an extremely cost-effective treatment.

Technical specifications

pH |||

3.54.5

Relative density Information |||

1.0251.05 at 25 °C

Applications

Biocide 7000 readily penetrates the surface of adhering biofilms and its biocidal action prevents micro-organisms from forming the sticky materials which are necessary to form biofilms in the first place. Thus Biocide 7000 is extremely effective against biofilm formation and at biofilm removal.

Biocide 7000 is stable over the wide range of conditions found in industrial water applications. It is stable in the presence of 1ppm free chlorine and its stability compared with many other biocides at different levels of pH, temperature and total water hardness is excellent. Biocide 7000  has been shown to be effective against Legionella species even at low concentration and high pH levels, although it is not recommended for use as a disinfectant. Further details are available
upon request.

Biocide 7000 is compatible with our entire range of corrosion and scale inhibitors and its stability and effectiveness in alkaline conditions makes it suitable for use as part of our 'High pH Solution for Open Evaporative Cooling Systems.

Characteristics and notes

ADVANTAGES

  • Broad spectrum activity against algae, fungi and bacteria, including
  • Legionella Pneumophila and sulphate reducing bacteria.
  • Very effective against biofilms.
  • Effective over a wide range of pH, temperature and water hardness.
  • Readily biodegradable when diluted.
  • Low toxicity.
  • Compatible with low levels of free chlorine or bromine as well acorrosion and scale inhibitors.
  • Can be used to disinfect certain ion exchange resins.
  • Does not contribute significantly to the AOX (Absorbable Organic
  • Halogens) level in a typical industrial effluent.
  • Does not interfere with the functioning of wastewater treatment plants, and is degraded readily by them.
  • Effective at low concentration - cost effective.
  • Not surface active - non-foaming.

HANDLING :

This product in a strong irritant to skin and eyes, both as a concentrate and as a solution. Eye and skin contact should be avoided by wearing PVC/ rubber gloves and goggles as well as protective overalls.

STORAGE :

Store in cool, well ventilated area. Keep container tightly closed. Do not store with Alkalies such as Category B and C products or oxidising agents such as Category I and J products.

Safety and SDS

Read the safety data sheet before handling. Wear suitable gloves and eye protection.

View safety data sheet
Product Name

BIOCIDE 7000

Product Type

RXSOL-41-8999-025

Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA

Stock Point : Mumbai, Kandla, Kolkata, Chennai, Vizag, Fujairah, Muscat

Phone +91 22 65113333/ 5555 / 9999 / 27611360 / 27815540
Fax +91 22 2781 1318+91 22 2781 1318 :::AOH :0091 9322594669
Email rxsolchemicals@gmail.com

Non-hazardous:
Pigmented Latex emulsion coating comprised of water, pigments, fillers, additives, and latex emulsion resin.
Hazardous:

Chemical Name               CAS#       Percent           Exposure Limits
1 - Titanium dioxide     13463-67-7    < 25.0            ACGIH TLV
                                                                                        10 mg/m3 as Dust
                                                                                         OSHA PEL
                                                                                        10 mg/m3 as Total Dust
                                                                                         5 mg/m3 Respirable Fraction
2 - Proprietary biocide*    N/A        < 0.10                  Not Established

Note: Normal application procedures pose no hazard since titanium dioxide is wetted and encapsulated, but grinding or sanding dried films of this product may yield respirable titanium dioxide dust. Control exposures to less than 0.1 mg/m3 using NIOSH-approved dust filter respirators.
Note: Per 29CFR 1910.1200 (g) (2) (1) (C) (2), only hazardous substances present in excess of 1.0% by weight (or 0.1% for carcinogens) must be listed on an MSDS.

Emergency Overview:

Product Description: This product is a pigmented liquid.

Health Hazards:

Eyes: May cause slight irritation.

Skin: Substance may cause slight skin irritation.

Inhalation: May cause irritation of respiratory tract.

Ingestion: Ingestion may cause gastrointestinal irritation, nausea, and vomitting.

Flammability Hazards: This product is not flammable. If this product is involved in a fire, the decomposition products generated will include irritating vapors and gases and some carbon monoxide.

Reactivity Hazards: This product is not reactive.

Environmental Hazards: Although release of this product to the environment is not expected to cause significant adverse effect, all releases should be avoided.

Eyes: Immediately flush eyes with plenty of water for at least 15 minutes and consult physician.

Skin: Wash skin thoroughly with soap and water. If drenched with product, remove and wash clothing before reuse.

Ingestion: Ingestion If victim is conscious give 2 glasses of water. Call a physician.

Inhalation: N/A

Product is non-combustible.

Flash point:                   Autoignition Temperature:
F: Not flammable          F: Not Established 
C: Not Established       C: Not Established

Extinguishing Media:
Use extinguishing media appropriate for surrounding fire

Water Spray : OK
Carbon Dioxide: OK
Foam: OK
Dry Chemical: OK
Halon: OK
Other: Any “ABC” Class

Accidental Release Measures:

Personal Precautions: Do not get in eyes. Do not take internally. Avoid skin contact. Prevent prolonged or repeated breathing of vapor or spray mists.
Keep unnecessary people away. Floor may be slippery, use care to avoid falling. Ventilate the area. Remove with inert absorbent.

Environmental Precautions: Keep spills and cleaning run-offs out of municipal sewers and open bodies of water. Comply with local, state and national regulations.

 

Handling and Storage: Store in a cool, dry place Keep closure tight and containers upright to prevent leakage.

Precautionary labeling: “KEEP FROM FREEZING”.

Precautions: Use only with adequate ventilation. Avoid contact with skin and eyes. Avoid breathing vapor and spray mist. Wash hands after using.

Work Hygienic Practices: Avoid contact with skin. Do not get in eyes. Do not take internally. Avoid breathing vapors or spray mists.

Ventilation: Use in well-ventilated areas. General exhaust acceptable if the exposure to materials in Section 2 is maintained below applicable exposure limits.

Refer to OSHA Standards 1910.94, 1910.107, 1910.108.

Respiratory Protection: If personal exposure cannot be controlled below applicable limits by ventilation, wear a properly fitted organic vapor/particulate
respirator approved by NIOSH/MSHA for protection against materials in Section 2. When sanding or abrading the dried film, wear a dust/mist respirator
approved by NIOSH/MSHA for dust which may be generated from this product, underlying paint, or the abrasive.

Eye Protection: Use approved safety eyewear including side shields, chemical goggles or face shields.

Skin Protection: Wear neoprene or rubber gloves to prevent skin contact if prolonged skin contact is likely. Wash hands before eating, smoking or using the wash room.

Appearance:

Viscous liquid

Viscosity @ 77°F:

60-75 Kreb Units ± 0.5

Odor:

Slight odor

Percent Solids By Weight:

51.5% ± 2.0

Boiling Point:

212°F

Solubility in Water:

Total

Freezing Point:

32°F

Vapor Density @ 68°F:

Heavier than air

Vapor Pressure (mmHg) @ 68°F:

17

Specific Gravity (H2O = 1) @ 68°F:

1.1 ± 0.1

Weight Per Gallon:

9.6 lbs/gal ± 0.5

Evaporation Rate:

Slower than ether

 

Stability: Stable

Incompatibility: (Material to Avoid): Avoid contact with strong oxidizing agents (e.g. nitric acid, permanganates), etc.

Hazardous Decomposition or By-Products: Some carbon monoxide.

Hazardous Polymerization: Will not occur.

Toxicological Information:
Chronic Health Hazards IARC’s Monograph No. 93 reports there is sufficient evidence of carcinogenicity in experimental rats exposed to titanium dioxide but inadequate evidence for carcinogenicity in humans and has assigned a Group 2B rating. In addition, the IARC summary concludes, “No significant exposure to titanium dioxide is thought to occur during the use of products in which titanium is bound to other materials, such as paint.”

Toxicology Data
Chemical Name            CAS No.               LD50
Titanium dioxide        13463-67-7             Oral: >24000 mg/kg (Rat)
                                                                        Dermal: >10000 mg/m3 (rabbit)
                                                                        Inhalation (Dust): >6.82 mg/L (Rat, 4hr.)

Ecological Information: No Data Available

Waste Disposal Method: Waste from this product is not hazardous as defined under the Resource Conservation and Recovery Act (RCRA) 40 CFR 261. If incinerating, do so in an approved facility, and do not incinerate closed container. Dispose of in accordance with Federal, State/Provincial, and Local regulations regarding pollution.

 

U.S. Department of Transportation

Proper Shipping Name: Non-Hazardous Water-Based Paint

Hazard Class: Not Regulated

Label Statement: Keep From Freezing Class 55 Non-Hazardous Water-Based Paint Canada (TDG)

Not Regulated for Transportation.

IMO

Not Regulated for Transportation.

U.S. Federal Regulations:

TSCA (TOXIC SUBSTANCE CONTROL ACT): All components of this product are in compliance with the inventory listing requirements of the U.S. Toxic Substances Control Act (TSCA) Chemical Substance Inventory.

CERCLA (COMPREHENSIVE RESPONSE COMPENSATION, AND LIABILITY ACT): Releases of this material to air, land, or water are not reportable to the National Response Center under the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) or to state and local emergency planning committees under the Superfund Amendments and Reauthorization Act (SARA) Title III Section 304.

SARA TITLE III: No ingredients in this product are subject to SARA 313 (40 CFR 372.65C) Supplier Notification.

CALIFORNIA SAFE DRINKING WATER AND TOXIC ENFORCEMENT ACT

(PROPOSITION 65): Components of this product are on the California Proposition 65 lists.

NOTES: (*)This proprietary biocide is listed as a carcinogen under California Proposition 65, however, a risk assessment was conducted by the biocide manufacturer and it was determined that when this product is used in accordance with label directions, exposure and thus risk is below the level which requires a Proposition 65 warning.

Titanium Dioxide is subject to the reporting requirements of Section 313 of the Emergency Planning and Community-Right-To-Know Act of 1986 and of 40 CFR 372.

CANADA DSL: All components are listed or exempt.

 

This product has been classified in accordance with the hazard criteria of the Canadian Controlled Products Regulations (CPR) and the MSDS contains all of the information required by the CPR.
To comply with New Jersey DOH Right-To-Know labeling law (NJAC 8:59 – 5.1 & 5.2)

CAS. No.:                CHEMICAL INGREDIENTS
7732-18-5                 Water
13463-67-7              Titanium dioxide
25265-77-4              2,2,4 - Trimethyl - 1, 3 - pentenediol
                                monoisobutyrate
Not Available          Proprietary surfactant
Not Available          Latex resin solids
                         

HMIS HAZARD RATING
Health 1                 Flammability 0      Physical Hazard 0           Personal
                                                                         Protection A
HAZARD INDEX: 0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe
                                     PERSONAL PROTECTION CODE:
A=Safety glasses

Warning! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and wet mop. Before you start, find out how to protect yourself and your family. 

DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.

Request the signed SDS as PDF

Availability

Biocide 7000 manufacturer supplier distributor in Mumbai, Kandla, Kolkata, Vizag, Chennai, India, Fujairah, Dubai, Sharjah, UAE, Gulf, Middle East, Muscat Oman, Kenya Africa. Get the best quality of Biocide 7000 at a competitive price from us. We have ready stock of Biocide 7000 in India, UAE Gulf, Oman, Kenya Africa. Contact us for bulk as well as small orders.

Our stock points and branches